Table of Contents
Advertisement
Wing20C+ Aerobar
INTRODUCTION
Thank you for purchasing this Profile Design Aerobar. These instructions apply to the Wing20C+ Aerobar.
Please read these instructions thoroughly before attempting to install this item. Proper installation is required for compliance with Profile Design's
warranty policy. If you are not familiar with installation of Aerobars or their accessories, please seek the assistance of your local Profile design dealer
by logging on to www.profile-design.com and using "dealer search" or by calling Profile Design's customer service number p.# 888.800.5999.
Note to Dealers: If you install this product for the consumer, please provide him/her with this owner's manual after installation.
Tools and materials required:
• 5mm Hex Wrench
• 4mm Hex Wrench
• Torque Wrench for a 5mm and 4mm Hex fitting
• Assembly compound such as Finishline Fiber Grip™
• Grease such as Finishline Premium Grease
• Threadlocker such as Loctite® Threadlocker Blue 242®
• Isopropyl alcohol
• Cutting guide
• Hacksaw (32T blade for carbon, 18T for aluminium)
• Or a pipecutter for aluminium
• Half round file
• Electrical/Insulation tape
• Clean, lint free cloth
1
Advertisement
Table of Contents
Need help?
Do you have a question about the WING20C+ and is the answer not in the manual?
Questions and answers