Tools And Materials Required - Profile Design ERGO+ ARMREST KIT Manual

Ergo+ & Race+ Armrest Kits
INTRODUCTION
Thank you for purchasing this Profile Design Armrest kit. These instructions apply to the Ergo+ and Race+ kits.
Please read these instructions thoroughly before attempting to install this item. Proper installation is required for compliance with Profile Design's
warranty policy. If you are not familiar with installation of Aerobars or their accessories, please seek the assistance of your local Profile design dealer
by logging on to www.profile-design.com and using "dealer search" or by calling Profile Design's customer service number p.# 888.800.5999.
Note to Dealers: If you install this product for the consumer, please provide him/her with this owner's manual after installation.

Tools and materials required:

• 4mm Hex Wrench
• Torque Wrench with a 4mm hex bit
• Grease such as Finish Line Premium Grease
1