Om13 Module Setting And Configuration - Emerson KEYSTONE OM13 EPI-2 Installation And Maintenance Instructions Manual

KEYSTONE OM13 - EPI-2 3-WIRES MODULE
INSTALLATION AND MAINTENANCE INSTRUCTIONS
• Connect the 3-pins connector cable of the
OM13 module to the logic card (Figure 47).
• Connect the 2-pins black connector from
OM13 module to the 2-pins connector
previously removed (Figure 48).
• Connect the 2-pins connector black cable
from the OM13 module to connector on the
logic card (Figure 48).
• The OM13 card is now connected.
• Replace the actuator cover and fix it properly.
IMPORTANT
Please note that all the connectors provided
with the base actuator and all optional cards are
different from each other (in terms of design and
number of pins). In no way is it possible to make a
wrong connection.
3. OM13 MODULE SETTING AND
CONFIGURATION
For the EPI-2 basic actuator settings, please
refer to the instruction and operation manual.
The OM13 does not need any setting and
configuration.
Warning
Do not electrically operate the EPI-2 when the
electrical enclosures are removed. Operating the
unit with the electrical enclosures removed could
cause personal injury.
Figure 47 Figure 48
8