Emerson KEYSTONE OM13 EPI-2 Installation And Maintenance Instructions Manual page 3

KEYSTONE OM13 - EPI-2 3-WIRES MODULE
INSTALLATION AND MAINTENANCE INSTRUCTIONS
• Connect the 2-wire power connector cable of
the OM13 card to the power card (Figure 9).
• Connect the 3-wire power connector cable
of the terminal board to the OM13 card
(Figure 10).
• Connect the 3-pins connector cable of the
OM13 module to the logic card (Figure 11).
• Reconnect the 8-pins connector cable and
4-pins connector cable (Figure 12).
• Connect the 2-pins black connector from
OM13 module to the 2-pins connector
previously removed (Figure 13).
• Connect the 2-pins connector black cable
from the OM13 module to the power card
(Figure 14).
2.2 Assembling procedure for models
250-500-1000-2000 Nm old version
(US or NO US market)
• Verify that you received the correct OM13
3-wire module (Figure 15).
• Remove (as indicate in Figure 16):
- 3-pins connector cable
- 4-pins connector cable
- 8-pins connector cable
Figure 9
Figure 11
Figure 13
Figure 15
Figure 10
Figure 12
Figure 14
Figure 16
3