Emerson KEYSTONE OM13 EPI-2 Installation And Maintenance Instructions Manual page 5

KEYSTONE OM13 - EPI-2 3-WIRES MODULE
INSTALLATION AND MAINTENANCE INSTRUCTIONS
• Connect the 2-pins connector black cable
from the OM13 module to connector J1A on
the logic card (Figure 25).
2.3 Assembling procedure for models
63-125 Nm new version (US or NO US market)
• Verify that you received the correct OM13
3-wire module (Figure 26).
• Remove (as indicate in Figure 27):
- 3-pins connector cable
- 4-pins connector white cable
- 4-pins connector black cable
- 8-pins connector cable
• Remove the 3-wire power connector cable
from the power card as indicated in Figure 28.
• Remove the 2-pins cable from connector on
the power card (Figure 29).
• Remove the 3 screws from the logic board;
screw the 3 metal spacers and insert the
plastic spacer (Figure 30).
• Place the OM13 card onto the spacers and
tighten the 3 screws (Figure 31).
• Connect the 2-wire power connector cable of
the OM13 card to the power card (Figure 32).
Figure 25
Figure 27
Figure 29
Figure 31
Figure 26
Figure 28
Figure 30
Figure 32
5