Emerson KEYSTONE OM13 EPI-2 Installation And Maintenance Instructions Manual page 4

KEYSTONE OM13 - EPI-2 3-WIRES MODULE
INSTALLATION AND MAINTENANCE INSTRUCTIONS
• Remove the 3-wire power connector cable
from the power card (Figure 17).
• Remove the 2-pins connector cable from J1A
on the logic card (Figure 18).
• Connect the 3-wire power connector cable
from the terminal board to the OM13
(Figure 19).
• Place the OM13 card onto the heatsink
spacers (if necessary use 3,2mm height
plastic spacers) and tighten the 4 screws
(Figure 20).
• Connect the 2-wire power connector cable of
the OM13 card to the power card (Figure 21).
• Reconnect the 8-pins connector cable and the
4-pins connector cable (Figure 22).
• Connect the 3-pins connector cable of the
OM13 module to the logic card (Figure 23).
• Connect the 2-pins black connector from
OM13 module to the 2-pins connector
previously removed (Figure 24).
Figure 17
Figure 19
Figure 21
Figure 23
Figure 18
Figure 20
Figure 22
Figure 24
4