Emerson KEYSTONE OM13 EPI-2 Installation And Maintenance Instructions Manual page 6

KEYSTONE OM13 - EPI-2 3-WIRES MODULE
INSTALLATION AND MAINTENANCE INSTRUCTIONS
• Reconnect the 8-pins connector cable and
4-pins connector black cable (Figure 33).
• Connect the 3-wire power connector cable
of the terminal board to the OM13 card
(Figure 34).
• Reconnect the 4-pins connector cable
(Figure 35).
• Connect the 3-pins connector cable of the
OM13 module to the logic card (Figure 36).
• Connect the 2-pins connector black cable
from the OM13 module to the power card
(Figure 37).
• Connect the 2-pins black connector from
OM13 module to the 2-pins connector
previously removed (Figure 38).
2.4 Assembling procedure for models
250-500-1000-2000 Nm new version
(US or NO US market)
• Verify that you received the correct OM13
3-wire module (Figure 39).
• Remove (as indicate in Figure 40):
- 2-pins connector cable
- 3-pins connector cable
- 4-pins connector white cable
- 4-pins connector black cable
- 8-pins connector cable
Figure 33
Figure 35
Figure 37
Figure 39
Figure 34
Figure 36
Figure 38
Figure 40
6