Moog T200 User Manual page 105

Programmable servo drive
Table of Contents

Advertisement

T200 User's Manual
3.14.6 Terminating the Motor Cable Shield (non-CE Applications) T200-3/4/5 only
Moog motor cables are supplied with a terminating crimp for the motor shield. The T200 provides two means of
termination of the motor cable shield.
1.
The motor cable shield crimp can be screwed into TB8-4 along with the MOTOR-GROUND crimp termination
from the motor cable. This is possible with G4x2, G4x3, G4x4 and G4x5 motor power cables.
2.
The motor cable shield crimp can be clamped underneath the EMC-bracket as shown in Figure 3.37 below. This is
necessary for G4x6 motor power cables. The user must purchase an EMC-Bracket for this purpose, even though he
does not require CE-Compliance.
Motor Cable Shield Termination crimp:-
Connect under the EMC Bracket provided.
Figure 3.37:- Attaching the T200 Motor Cable Shield via the Clamp, for a G4x6 motor.
PAGE 3-66
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SECTION 3: WIRING AND INSTALLATION

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T200 and is the answer not in the manual?

Table of Contents

Save PDF