Table of Contents
Advertisement
Section 2 — Installation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Axis #
Figure 2-2: Installation View of Jumpers inside the DCIB
6. Set the jumpers and current setting as needed (See Table 2-1, A, B, C,
and D) on the DC Module.
7. Insert the DC Module in the appropriate axis location. Observe the
three jumper headers on the DC Interface Box are also used as a key
for proper module location.
8. Place the DC Interface Box's top cover back on the unit, and secure it
with the four screws.
9. The DC Interface Box is now ready to be reconnected and powered on.
In order for a DC Module to be functional, an appropriate power supply
must be connected to the DC Interface Box.
Cut +LIMIT
and –LIMIT traces
between pads per
table D
Remove jumpers
Universal
Interface Board
Silk-screen
NOTE
2-3
Advertisement
Table of Contents
