Section 2 - Installation; Connecting The Dcib To Mm2000 Or Esp6000 Motion Controllers - Newport MM2000 Operator's Manual

Section 2 — Installation
2.1

Connecting the DCIB to MM2000 or ESP6000 Motion Controllers

Section 2 — Installation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
AUX
Figure 2-1: View inside the DC Interface Box
Connect MM2000 to Motors and/or Drivers:
The motor control signals generated by the MM2000 appear at the 68-pin
output connector at the back of the user's computer. With the MM2000 the
user received a DC Interface Box, which divides the 68 signals into 4 axes
of motor control.
Locate the enclosed 68-pin shielded cable, connect one end to the
MM2000 output connector, and connect the other end to the DC Interface
Box.
The user should connect the motors and motor drivers to the 25 pin out-
put connectors on the rear panel of the DCIB. The connectors are labeled
AXIS 1, AXIS 2, AXIS 3, and AXIS 4.
See Section 3 of the MM2000 Quick Installation and Start Up Guide,
Revision 3.2, for hook-up instructions.
PWR1
Main Connector
Location
NOTE
PWR2
2-1