Table of Contents
Advertisement
1.3
Description of Panel Functions on DCIB
1-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
AC
Transformer
(Power Source)
A = Electronic circuitry is monitoring this point.
If voltage is between 12 -19V, the relay will close and NORMAL (Green) LED
will illuminate.
If voltage is under 12 volts, relay will open and LOW (Red) LED will illuminate.
If voltage is over 19 volts, relay will open and HIGH (Red) LED will illuminate.
Summary: The DCIB DC Module is NOT operating if the Green LED is not
illuminated!
Front Panel:
The Front Panel of the DCIB includes the following items, reading left to
right:
AUX
This is a 15-Pin Connector that gives access to the I/O bits
or, with simple modifications on the board, to the encoder
or pulse train signals. (See Pinouts in Section 3 of this
manual).
Main
This is a 68-Pin Connector used for an Interconnect Cable
Connector
link, from the MotionMaster2000 or ESP6000 motherboard
to the DCIB (See Pinouts in Section 3 of this manual).
LED's
External Power Voltage status is indicated by three Light
Emitting Diodes (LED): LOW, NORMAL, and HIGH.
• LOW (Red) - This LED is for LOW Power Voltage, and is
illuminated when DCIB power is on.
• NORMAL (Green) - This LED is for NORMAL Power
Voltage.
• HIGH (Red) - This LED is for HIGH Power Voltage.
PWR 1
This is an external power supply connector to be used
when a DC driver module is present.
PWR Relay
DC
Rectifier
A
Amplifier
UIB
Advertisement
Table of Contents
