Table of Contents
Advertisement
Section 1 — Introduction and Overview
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PWR 2
This secondary power connector can be powered by a
transformer with a center tap, or by an external dual volt-
age power supply (See Figure 1-3).
Safety
Fused
Line
Figure 1-3: PWR2 AC Powered
Safety
Fused
Line
Figure 1-4: PWR2 - DC Powered
Polarity Orientation not important!
Recommended transformer to be used with the DCIB:
• AC-AC Wall Mount Adapter with the following specifications:
12VAC at 2 amps (To be connected to PWR1 on the front panel of the
DCIB). An AC – AC wall mount adapter (P/N 22588-01 for 110V line) is
included if at least one driver module is installed.
Rear Panel:
The four (4) connectors on the rear panel are labeled: AXIS 1, AXIS 2, AXIS
3, and AXIS 4. These connectors are used for connections to DC Servo
Motors, or MD4 Driver.
PWR2
12V
12V
PWR2
+15V
DC
Power
0V
Supply
–15V
NOTE
1-5
Advertisement
Table of Contents
