Connection; Preparation - Sony BRC-Z700 Service Manual

3-1-2. Connection

AD-181 board
BRC-Z700
DC-IN
VISCA IN
Card slot
Extension board
EX-1089
CN003
Infrared remote
controller

3-1-3. Preparation

1. Install FCB control software, system FPGA writing software, camera FPGA writing software and
CPU writing software in PC.
2. Remove the outer cover (right)/(left), inner cover (center)/(right)/(left), inner cover (front) assembly,
inner cover (rear), camera cover (upper), front cabinet assembly, camera cover (lower).
(Refer to Sections 1-2-1 to 1-2-7.)
3. Connect each equipment. (Refer to Section 3-1-2.)
4. Turn on the power of equipment other than this unit.
m
. When using USB BLASTER REV C for an FPGA write cable, be sure to turn on the power of PC
and then turn on the power of this unit. Also, turn off the power of PC after turning off the power
of this unit.
. Connect the fixture cable to CN1201 on the AD-181 board only when writing of camera FPGA.
The connection except in camera FPGA writing may cause the break of fixture cable or connector
by the pan-tilt initialization behavior at power-on.
3-2
CN1201
Fixture cable
VISCA cable
RGB/COMPONENT
D-sub 15-pin 5 BNC
S004
H
L
S003
WRITE
NORMAL
FPGA write cable
Personal computer
Platform cable
USB
RS-232C
S005 S006
H H
BNC cable
L L
Frequency counter
S002 S001
ADJ
OPE
AC adaptor
AC-IN
HD monitor
HD ch.
75 Z
termination
Oscilloscope
G/B/R/VD ch.
75 Z
termination
BRC-Z700