16. Remove the TSI-59 board.
(Refer to steps 5 and 6 in Section 2-2-6.)
17. Remove the holder screw (T) using the KANIME tool.
n
When attaching the holder screw (T), tighten the screw
to the tightening torque as shown below.
Tightening torque: 2.5 N.m
18. Remove the wave washer and washer (T).
n
When attaching the washer (T) and wave washer,
securely attach them between the ball bearing and the
screw holder (T).
19. Remove the three screws, bearing holder (tilt) and two
ball bearings.
Ball bearings
BRC-Z700
KANIME tool
Holder screw (T)
Bearing holder (tilt)
Holder screw (T)
PSW
2.6 x 6
Washer (T)
Wave washer
20. Remove the hook while pushing the clamp in the
inserting direction, then remove the clamp.
21. Remove the two screws, then remove the shield spring
and bearing (T).
22. Remove the camera block assembly in the direction of
the arrow being careful of the flexible flat cable.
Shield spring
PSW2.6 x 6
Bearing (T)
Clamp
Hook
LVDS harness
assembly
Camera block assembly
Flexible flat cable
2-3