Sync Output Level Adjustment; G/Y Video Output Level Adjustment; B/Pb Video Output Level Adjustment; R/Pr Video Output Level Adjustment - Sony BRC-Z700 Service Manual

3-2-5. SYNC Output Level Adjustment

1. Turn on the power of this unit.
2. Press the [DATA|SCREEN] button of an infrared
remote controller four times and display "EVR_CAM
no:001 data:xxx".
3. Press the [*] button of an infrared remote controller to
display "EVR_CAM no:007" and adjust the display to
data:255 using a [(] button.
4. Press the [&] button of an infrared remote controller to
display "EVR_CAM no:006 data:xxx".
5. Press the [(] and [)] buttons of an infrared remote
controller so that the SYNC output level satisfies
specifications A.
6. Turn off the power of this unit.

3-2-6. G/Y Video Output Level Adjustment

1. Turn on the power of this unit.
2. Press the [DATA|SCREEN] button of an infrared
remote controller four times and display "EVR_CAM
no:001 data:xxx".
3. Press the [*] button of an infrared remote controller to
display "EVR_CAM no:003 data:xxx".
4. Press the [(] and [)] buttons of an infrared remote
controller so that the SYNC level of a G/Y video
output signal satisfies specifications A.
5. Turn off the power of this unit.
BRC-Z700
A=600 ±5 mV
A=600 ±5 mV

3-2-7. B/Pb Video Output Level Adjustment

1. Turn on the power of this unit.
2. Press the [DATA|SCREEN] button of an infrared
remote controller four times and display "EVR_CAM
no:001 data:xxx".
3. Press the [*] button of an infrared remote controller to
display "EVR_CAM no:004 data:xxx".
4. Press the [(] and [)] buttons of an infrared remote
controller so that the SYNC level of a B/Pb video
output signal satisfies specifications A.
5. Turn off the power of this unit.

3-2-8. R/Pr Video Output Level Adjustment

1. Turn on the power of this unit.
2. Press the [DATA|SCREEN] button of an infrared
remote controller four times and display 'EVR_CAM
no:001 data:xxx".
3. Press the [*] button of an infrared remote controller to
display "EVR_CAM no:005 data:xxx".
4. Press the [(] and [)] buttons of an infrared remote
controller so that the SYNC level of an R/Pr video
output signal satisfies specifications A.
5. Turn off the power of this unit.

3-2-9. SD-SYNC Output Level Adjustment

1. Turn on the power of this unit.
2. Press the [DATA|SCREEN] button of an infrared
remote controller four times and display "EVR_CAM
no:001 data:xxx".
3. Press the [*] button of an infrared remote controller to
display "EVR_CAM no:009" and adjust the display to
data:097 using a [(] button.
4. Turn off the power of this unit.
n
SYNC signal is output from VD ch.
A=600 ±5 mV
A=600 ±5 mV
3-7