Table of Contents
Advertisement
Operating manual
1
12
Fig. 3e. Overview of rear disk mower (swath rollers)
1 – Suspension frame
2 – Lifting actuator
3 – Crop rollers
4 – Cutterbar
5 – Crop guides
6 – Safety cover
7 – Miter gear I
The suspension frame (1) allows the mower to be connected to the three point hitch of
the tractor.
The power from the PTO of the tractor is transferred by the drive shaft, miter gear (7) to
the drive shaft (9), which through the miter gear (8) powers the cutter(4). Additionally power
from the PTO of the tractor is transferred through the miter gear (7), the drive shaft (9), miter
gear (8) and the chain drive (13) to the crop rollers (3).
On the cutterbar (4) there are discs with two cutting blades each.
The hydraulic lifting actuator (2) powered by the external hydraulic system of the tractor is
used to place the mower into operating position.
The main frame on which the cutterbar is mounted is supported by the spring suspension (14).
The mower is also equipped with a rotational actuator (10), which has two functions. The first
one is the ability to fold the mower backwards which, in many cases, significantly simplifies
transport, while the second is the factory calibrated hydraulic safety device (11).
The crop guides (5) are installed on the upper cover of the scarifier.
On the 3-point linkage frame there is safety guard (6) mounted.
Support foot (1) is mounted to 3-point linkage frame (1).
10
11
14
7
9
(For: KT 260 W, KT 300 W)
Rear disc mowers with central suspension
- with hydro-pneumatic or spring suspension
2
8
4
13
5
8 – Miter gear II
9 – PTO I
10 – Rotational actuator
11 – Hydraulic safety device
12 – Support foot
13 – Chain drive
14 – Spring suspension
- 1 2 -
6
3
Advertisement
Table of Contents
