pulling-in of clothes.
The lathe includes the following safety devices:
an emergency-stop switch,
a lathe chuck protection with position switch,
a protective cover on the headstock with switch,
a safety screw at the tailstock,
a mechanical spindle brake,
an protective cover on lead screw.
an overload clutch on the feed rod,
a chips shield.
WARNING!
Although the isolating safety devices provided and delivered with the machine are desi-
gned to reduce the risks of workpieces being ejected or parts of tools or workpieces bre-
aking off, they cannot eliminate these risks completely.
1.9.1
Emergency-stop button
CAUTION!
The drive or the lathe chuck will continue to run for a while, depending on the mass
moment of inertia of the lathe chuck and the workpiece.
The emergency stop button brings the machine to a standstill.
Turn the knob to the right to unlock and release the emergency stop button.
CAUTION!
Only press the emergency-stop button in a genuine emergency. Do not use the
emergency stop button to stop the machine during normal operation.
1.9.2
Protective cover of the headstock
The headstock of the lathe is equipped with a separating protective cover. The protective cover
is equipped with a switch.
1.9.3
Lathe chuck protection with position switch
The lathe is equipped with a lathe chuck protection. The spindle of the lathe can only be swit-
ched on if the lathe chuck protection is closed.
1.9.4
Protective cover of lead screw
The lead screw of the lathe is equipped with a protective cover.
1.10
Safety check
Check all safety devices
when starting any work,
once a week,
after all maintenance and repair work.
INFORMATION
Use the following summary to perform the checks.
EN
TM3310 | TM3310D
12
Translation of original instruction
Safety
Version 1.0.2 - 2020-07-20