Table of Contents
Advertisement
definition, and begins performing this command.
• Refer to <Function 1> of this command for the setting values for this function.
[Default]
None
[Relative]
<Function 1>
GS ( M pL pH n m ((n) = 3, 51) < Function 3>
[Format]
ASCII
Hex
Decimal
[Value range]
( pL + ( pH×256)) = 2 ( pL = 2, pH = 0)
n = 3, 51
0 ≤m ≤1, 48 ≤m ≤49
[Notes]
• When m = 0 or 48, the printer does not load the data from the user NV memory at the
initialization. After the initialization, the setting value of GS ( F becomes the default
value of the printer.
• When m= 1 or 49, the printer loads the data from the user NV memory at the
initialization.After the initialization, the setting value of GS ( F becomes the setting
values which are stored in the memory.
• The specified data by this command are stored in NV memory.If the data will be
written in the the memory which are already written with the same data, the data
saving process is not executed.
• If an error occurs in the process of writing the data, the printer will execute the
memory error process.
[Notes]
When the data is automatically loaded, the initialization process is executed when any
of the following process is executed:
• Power-on process by the power switch
• When the hardware reset is executed by the interface reset
• Execution of ESC @
[Default]
m = 0
[Relative]
ESC @, <Function 1> of this command.
GS : Start/end macro definition
[Function]
Start/end macro definition
[Format]
ASCII
Hex
Decimal 29
[Notes]
• Macro definition starts when this command is received during normal operation.
Macro definition ends when this command is received during macro definition.
• When GS ^ is received during macro definition, the printer ends macro definition and
clears the definition.
GS
(
1D
28
29
40
GS
:
1D
3A
58
M
pL
4D
pL
77
pL
- 62 -
BT-T080 Programming Manual
pH
n
m
pH
n
m
pH
n
m
Advertisement
Table of Contents
