Vanraam Fun2Go User Manual page 22

Possible malfunctions
The system does not turn on:
•
1. Make sure that the battery is properly attached.
2. Check the status of the battery. If it is empty, recharge the battery.
3. If the above action does not help, contact your dealer.
If the battery indicator LED lights on the display are flashing:
•
The motor may be overheated by continuous high load. For protection, the system will
reduce the support.
1. The system is in temperature-protection. You can continue cycling with reduced
support.
2. After cooling down, the normal support and indication will restore automatically.
If the support LED lights on the display are flashing:
•
This indicates motor failure. You will need to contact your dealer.
If a red LED light on the charger starts flashing, remove the plug form the mains outlet
•
and do not longer use the charger. In this case, contact your dealer.
Charger Safety Measures
Only charge Van Raam Li-Ion batteries with the included charger. Only connect the
•
charger to a suitable power point (220-240 Volt AC 50-60 Hz). If the charger is not
being used, unplug it from the socket and take the plug out of the battery.
The charger may only be used by people who have read the information in this user
•
manual and are familiar with the proper use of the charger. Keep the charger out of
reach of children; do not let them play with it.
The charger has been designed for use in a dust-free, dry, and ventilated environment.
•
Do not expose the charger to water, heat sources, and direct sunlight. Keep the
charger clean and dry.
Do not charge batteries that feel hot to the touch. The battery may not be hotter than
•
room temperature for charging. Stop charging if the battery becomes abnormally hot
(>40°C). Please note! The charger may become hot during charging > 50 °C. First
carefully feel if it is safe to touch the charger. This temperature can cause sensitivity or
startle if it comes into contact with the skin.
Do not use the charger if it is visibly damaged or modified. Do not repair the charger!
•
Please contact Van Raam. Never open the charger yourself!
While charging, please monitor the charger and the battery. Once the battery is full,
•
remove the plug from the socket and the plug out of the battery.
Version 21.01
22/43