Vanraam Fun2Go User Manual page 19

4. Then insert the connector of the charger into the
charging point of the battery. The red LED will light
up. The charger is now charging.
Please note! If the battery is not connected
properly, the green LED will light up (standby
mode). If the connection is poor, unplug the plug
from the socket and clean the charger's
connector with a dry cloth.
5. The charging time depends on the level of the
battery. The charging time is about 2 hours for a
10.7 Ah and about 4,5 hours for a 24.8 Ah battery.
6. Once the battery is fully charged, the green LED will
be solid. Now first remove the charging connector of
the charger from the connector of the battery.
7. Then unplug the charger from the socket.
8. Put the battery back in the holder of the
cycle and close the lock.
If necessary, the battery can also be charged
directly on the cycle.
Charger:
LED Status
indication
Green Standby / battery full
Red Charging
Red, blinking Safety: Polarity inversion; Short; Over temperature; Over power;
Over voltage
It is better for the battery if it is charged regularly, rather than wait until it is
completely drained. Never leave the bike with a drained battery!
Ensure that the battery is always pushed straight into the holder.
Version 21.01
4.
19/43