OSTLING EMP/MODULMAT Operating Manual page 30

Setting the During the off periode no current flows. The stencil does not continue to heat
off periode itself.
10. Press ↓ (5) until parameter "Off periode" appears.
11. Press ENTER (6).
12. To increase the off periode: press ↑ (4).
13. To decrease the off periode: press ↓ (5).
14. To reject the settings: press MENU (7). To assume the settings: press
If you want to shift during a pulse marking between alternating (AC) and direct
DC/AC automatic
current (DC) DC/AC automatic must be ON. Only in this case the parameters
"=/~ time" and "=/~ mark power" are considered during the marking.
The marking starts with the current type that is selected with the pushbutton
AC/DC (8) (see page 26).
15. Press ↓ (5) until parameter "=/~ automatic" appears.
16. Press ENTER (6).
17. Press ↓ (5) until DC/AC automatic is ON or OFF.
18. To reject the setting: press MENU (7). To assume the setting: press ENTER
Setting the Pulse marking with direct (DC) and alternating current (AC): Time after that the
DC/AC time type of current is changed.
19. Press ↓ (5) until parameter "=/~ time" appears.
20. Press ENTER (6).
21. To increase the DC/AC time: press ↑ (4).
22. To decrease the DC/AC time: press ↓ (5).
23. To reject the settings: press MENU (7). To assume the settings: press
ÖSTLING Markiersysteme GmbH
Each press increases the time of the off periode in steps of 0.1 s. The maxi-
mum value is 5.0 s.
Each press decreaes the time of the off periode in steps of 0.1 s. The mini-
mum value is 0.1 s.
ENTER (6).
Menu "Mark options" appears.
(6).
Menu "Mark options" appears.
Each press increases the DC/AC time in steps of 0.1 s. The maximum
value is 15.0 s.
Each press decreases the DC/AC time in steps of 0.1 s. The minimum
value is 0.1 s.
ENTER (6).
Menu "Mark options" appears.
B_EU_EMP_en.doc
Operation manual EMP
30