OSTLING EMP/MODULMAT Operating Manual page 23

Setting the During the pumping time the electrolyte pump runs. The pumping time begins at
pumping time the same time as the marking time.
12. To increase the pumping time PT: press ↑ (4).
13. To decrease the pumping time PT: press ↓ (5).
14. To reject the settings: press MENU (7).
15. To assume the settings: press ENTER (6).
During the retarding time no voltage is impressed, the marking is "retarded".
Setting the
retarding time The retarding time begins when the foot switch is pressed.
16. To increase the retarding time RT: press ↑ (4).
17. To decrease the retarding time: press ↓ (5).
18. To reject the settings: press MENU (7).
19. To assume the settings: press ENTER (6).
The marking counter counts each marking performed.
Marking counter
20. Press ↓ (5), to set the counter on zero.
21. To reject the setting on zero: press MENU (7).
22. To confirm the setting on zero: press ENTER (6).
Note
If the equipment is equipped with a hard metal output, a second red connection
(19, Fig. 10009, page 11) is on the backside. 10 V, AC are impressed
permanently on the hard metal output. This voltage cannot be adjusted. When
connecting the red positive cable to the hard metal output the pushbuttons
AUTOMATIC (9) and TIMER (10) are not active.
ÖSTLING Markiersysteme GmbH
Each press increases the pumping time in steps of 0.1 s. The maximum
value is 10.0 s.
Each press decreases the pumping time in steps of 0.1 s. The minimum
value is 0.1 s.
Main menu appears.
If the option "Retarder" is activated, the submenu "Time RT" appears.
Otherwise the main menu appears.
Each press increases the retarding time in steps of 0.1 s. The maximum
value is 10.0 s.
Each press decreases the retarding time in steps of 0.1 s. The minimum
value is 0.1 s.
Main menu appears.
If the option "Marking counter" is activated, the submenu "Marking counter"
appears. Otherwise the main menu appears.
Main menu appears.
Main menu appears.
B_EU_EMP_en.doc
Operation manual EMP
23