10.17
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place handlebar supports in required position. Mount and tighten
2
screws
.
Guideline
Screw, handlebar
support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
F03177-10
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the installed gaps are even.
Finishing work
–
Mount the handlebar cushion.
TUNING THE CHASSIS 10
1
. Take off the handlebar clamps. Remove the
2
. Take off handlebar supports.
M10
40 Nm (29.5 lbf ft)
1
M8
20 Nm (14.8 lbf ft)
Loctite
®
243™
and tighten
43