13 WHEELS, TIRES
13.2
13.3
88
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Removing the rear wheel
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
spacers.
Long-life grease (
–
Insert the spacers.
–
Clean and grease the wheel spindle.
H00935-10
Long-life grease (
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake linings
are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times firmly.
A00839-11
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with a lift stand. (
1
and contact surfaces
p. 131)
p. 131)
2
.
M20x1.5
35 Nm (25.8 lbf ft)
3
.
M8
15 Nm (11.1 lbf ft)
p. 44)
A
of the
p. 44)