Uninstalling The Hardware And Software; Uninstalling The Hardware - National Instruments PC/104-GPIB Manual

Uninstalling the
Hardware and Software

Uninstalling the Hardware

© National Instruments Corporation
This appendix describes how to uninstall your PC/104-GPIB and GPIB
software for Windows 95.
Before you physically remove the GPIB hardware from your system,
you must remove the hardware information from the Windows 95
Device Manager. Complete the following steps to remove the hardware
information:
1. Select Start»Settings»Control Panel and double-click on the
System icon.
2. In the System Properties dialog box, select the Device Manager
tab, click on the View devices by type button, and double-click on
the National Instruments GPIB Interfaces icon.
3. Select the interface you want to remove from the National
Instruments GPIB Interfaces list, as shown in Figure A-1. Click
on the Remove button to remove the hardware information.
4. Click on the OK button, shut down Windows 95, turn off your
system, and physically remove the interface from your system.
A-1
Appendix
A
PC/104-GPIB for Windows 95