Assign An Interface Name; Figure 2-17. Gpib Settings Page For The Pc/104-Gpib - National Instruments PC/104-GPIB Manual

Chapter 2 Installation and Configuration

Assign an Interface Name

PC/104-GPIB for Windows 95
If you are using more than one interface, you must configure the GPIB
software to associate a logical name (
each physical GPIB interface. Follow these steps:
1. Double-click on the first interface immediately below National
Instruments GPIB Interfaces.
2. Click on the GPIB Settings tab, which provides information about
the software configuration for the PC/104-GPIB.
3. Use the Interface Name drop-down box to select a logical name
( , , and so on) for the PC/104-GPIB.
GPIB0 GPIB1
4. Repeat this process for each interface you need to configure.

Figure 2-17. GPIB Settings Page for the PC/104-GPIB

GPIB0
2-20
, , and so on) with
GPIB1
© National Instruments Corporation