Table of Contents
Advertisement
Troubleshooting and
Common Questions
Troubleshooting EDVR Error Conditions
EDVR Error Condition with ibcntl Set to 0xE028002C (-534249428)
EDVR Error Condition with ibcntl Set to 0xE0140025 (-535560155)
EDVR Error Condition with ibcntl Set to 0xE0140035 (-535560139)
© National Instruments Corporation
This appendix describes how to troubleshoot problems and answers
some common questions.
In some cases, calls to NI-488 functions or NI-488.2 routines may
return with the ERR bit set in
value stored in
ibcntl
If a call is made with a board number that is within the range of allowed
board numbers (typically 0 to 3), but which has not been assigned to a
GPIB interface, an EDVR error condition occurs with
0xE028002C. You can assign a board number to the PC/104-GPIB by
configuring the GPIB software and selecting the name of the
PC/104-GPIB. For information about how to configure the GPIB
software, refer to the
Chapter 2,
Installation and
If a call is made with a board number that is not within the range of
allowed board numbers (typically 0 to 3), an EDVR error condition
occurs with
set to 0xE0140025. Refer to the
ibcntl
Name
section of Chapter 2,
If a call is made with a device name that is not listed in the logical
device templates that are part of the GPIB Configuration utility, an
EDVR error condition occurs with
the
View or Modify Logical Device Templates (Optional)
Chapter 2,
Installation and
and the value EDVR in
ibsta
is useful in troubleshooting the error condition.
Configure the GPIB Software
Configuration.
Installation and
ibcntl
Configuration.
B-1
Appendix
B
iberr
set to
ibcntl
section of
Assign an Interface
Configuration.
set to 0xE0140035. Refer to
section of
PC/104-GPIB for Windows 95
. The
Advertisement
Table of Contents
Troubleshooting
