National Instruments PC/104-GPIB Manual page 7

Appendix C
Specifications
Hardware Characteristics .................................................................................................C-1
Software Transfer Rates...................................................................................................C-2
Appendix D
Customer Communication
Glossary
Figures
Figure 2-1.
Figure 2-2.
Figure 2-3.
Figure 2-4.
Figure 2-5.
Figure 2-6.
Figure 2-7.
Figure 2-8.
Figure 2-9.
Figure 2-10. PC/104-GPIB Interrupt Jumper Setting for IRQ5 ................................. 2-13
Figure 2-11. PC/104-GPIB DMA Jumper Setting for DMA Channel 7 .................... 2-15
Figure 2-12. PC/104-GPIB DMA Jumper Setting for No DMA Channel ................. 2-15
Figure 2-13. PC/104-GPIB Ground Configuration Jumper Settings.......................... 2-16
Figure 2-14. Installing the PC/104-GPIB ................................................................... 2-17
Figure 2-15. PC/104-GPIB That Is Working Properly............................................... 2-19
Figure 2-16. PC/104-GPIB That Is Not Working Properly........................................ 2-19
Figure 2-17. GPIB Settings Page for the PC/104-GPIB............................................. 2-20
Figure 2-18. Device Templates Page for the Logical Device Templates ................... 2-21
Figure 3-1.
Figure A-1.
Figure A-2.
Figure B-1.
© National Instruments Corporation
Add/Remove Programs Properties Dialog Box ..................................... 2-2
GPIB Software Setup Screen ................................................................. 2-3
Add New Hardware Wizard Hardware Selection.................................. 2-5
PC/104-GPIB Resources Assigned Successfully .................................. 2-6
PC/104-GPIB Resources Not Assigned Successfully ........................... 2-6
PC/104-GPIB Resources Settings.......................................................... 2-7
PC/104-GPIB Parts Locator Diagram.................................................... 2-9
PC/104-GPIB Base I/O Address Switch Settings.................................. 2-12
PC/104-GPIB Interrupt Jumper Setting for IRQ11 (Default Setting) ... 2-13
Diagnostic Utility after Testing ............................................................. 3-1
Selecting the PC/104-GPIB ................................................................... A-2
Add/Remove Programs Properties Dialog Box ..................................... A-3
PC/104-GPIB That Is Not Working Properly........................................ B-3
vii
Contents
PC/104-GPIB for Windows 95