National Instruments PC/104-GPIB Manual page 28

© National Instruments Corporation
Table 2-2. Possible Base I/O Address Switch Settings (Continued)
Switch Settings
A9 A8 A7
1 1 0
1 1 0
1 1 1
1 1 1
1 1 1
1 1 1
2. Change the switch settings to configure the GPIB module to match
the base I/O address of the Input/Output Range assigned by
Windows 95.
Press down on the side marked OFF to select a binary value of 1 for
the corresponding address bit. Press down on the ON side of the
switch to select a binary value of 0. Refer to Figure 2-8 for an
example of the switch settings and corresponding base I/O
addresses.
Chapter 2
Base I/O
A6 A5
Address (hex)
1 0 340
1 1 360
0 0 380
0 1 3A0
1 0 3C0
1 1 3E0
2-11
Installation and Configuration
I/O Address Space
Used (hex)
340 to 35F
360 to 37F
380 to 39F
3A0 to 3BF
3C0 to 3DF
3E0 to 3FF
PC/104-GPIB for Windows 95