BACNet Flow CoNtroller
DISPLAY NAVIGATION
Initial Startup
When the BFC controller is powered up with 24VAC it will display the following information.
PrICe
eleCtroNICS
BFC
VerSIoN
CUrr
PreSSUre
eCM SetPoINt
UNIt StAtUS
CoNtrol MoDe
CUrreNt CFM
*LCD display will cycle between Curr Pressure, ECM Setpoint, Unit Status, Control Mode, and Current CFM during normal
operation.
Change ECM motor setpoint using
loCAl eCM
58%
Note:
Local setpoints are stored to EEPROM and will remain set after power failures.
Start–up screen
Displays firmware version
Displays the current static pressure in in. w.g.
Displays ECM setpoint in % motor speed
Displays current unit status (Off, Low Pressure, Normal, Filter Loaded)
Displays the current control mode (BACnet, BAS, Local Control)
Displays the current airflow (only visible with the Constant Flow motor program)
and
arrow keys
Setpoint will save after being adjusted with arrow keys
priceindustries.com | BACNet FLow CoNtroLLer - Manual
3