Table of Contents
Advertisement
BACNet Flow CoNtroller
NETWORKING & SETUP
wiring and Cables
*For In depth ECM motor troubleshooting, please refer to ECM Troubleshooting Manual on Price Industries' website.
The ECM speed controller requires 24 VAC power from a transformer and outputs control signals to the ECM motor on dual MTA-
100 jacks. Either jack or both jacks can be used (for dual fan systems).
The control cable (with RED connector) must be plugged into the circuit board correctly. (See Figure 2)
FIGUre 2 - eCM StANDArD SPeeD CoNtroller wItH CoNtrol CABle PlUGGeD INto Mtr1
MTR1 JACK
ECM CONTROL CABLE (NOTE: ORIENTATION)
Note:
Make sure that this cable is connected properly. It is keyed one way, and make sure all of the pins are covered.
priceindustries.com | BACNet FLow CoNtroLLer - Manual
25
Advertisement
Table of Contents
