Advertisement
DELUXE ECM SPEED CONTROLLER
PRODCUT OVERVIEW
General
The Price Deluxe ECM speed controller works with a high
efficiency ECM motor. This low voltage (24VAC) speed control
allows full manual (push button adjust) or BAS (2-10VDC
signal) control of the ECM motor.
Features:
•
Dual outputs for controlling 2 ECM motors
•
Red four-digit digital display for reading out:
a) Speed 0 -100%
b) Motor RPM
c) BAS input voltage
•
Building Automation System input (2-10VDC) for remote
control
LED Digital Display
The Digital Display shows the user several modes of operation. This allows for easier and more precise field adjustment and
troubleshooting. To change modes press both up and down buttons at the same time.
NOTE:
Local setpoints are stored to EEPROM and will remain set after power failures.
WARNING:
Do not switch 120/208/240/277 VAC power to turn ECM motor on and off. Instead control the 24VAC signal or BAS
signal to turn the ECM motor on and off. The ECM motor has large capacitors that charge quickly on mains power up. Switching
on several motors frequently could reduce building power quality.
Specifications
Display
L.SEt
rPn
bAS.r
bAS.S
Power:
Operating Conditions:
Storage Conditions:
Processor:
Inputs:
Outputs:
Connections:
Dimensions:
Shipping Weight:
Local Setpoint - Manual Speed Adjust Mode (use UP/DOWN to adjust)
RPM - Shows current RPM mode of ECM motor 1.
If E001 is displayed – no RPM pulses are being read. Check 6 position cable.
If E002 is displayed – RPM reading is over 2000 RPM. Check primary air.
BAS remote - BAS Mode – Voltage Signal (Max display reading is 9.99 VDC)
BAS Setpoint - Current BAS setpoint
24 VAC +-10% @ 50/60Hz (2VA)
0°C to 50°C (32°F to 122°F) 0% – 95% R.H. non-condensing
-30°C to 50°C (-22°F to 122°F) 0% – 95% R.H. non-condensing
8-bit enhanced flash microcontroller
1 Analog (BAS) and 3 digital inputs (push buttons and RPM)
2 Digital (GO signal to ECM and Vspd PWM signal @ 80.0 Hz), Display, and aux analog output
¼" Spade Terminals – Recommend 16 - 22AWG copper wire
2.8" by 3.8" [71mm by 96mm] (includes mounting plate)
0.220 lbs, 100 grams
ECMDX
Mode
priceindustries.com | DELUXE ECM SPEED CONTROLLER - Manual
Range
0-100%
0-1500 RPM
0-9.99 VDC
0-100%
1
Advertisement
