Table Of Contents - Emerson Rosemount 3051 Quick Start Manual

Quick Start Guide
NOTICE
This guide provides basic guidelines for Rosemount 3051 Wireless Transmitters. It does not provide
instructions for configuration, diagnostics, maintenance, service, troubleshooting or Intrinsically Safe (I.S.)
installations. Refer to the Rosemount 3051 Wireless Reference Manual (document number
00809-0100-4100) for more instruction. This manual is also available electronically on
www.rosemount.com.
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the appropriate local,
national, and international standards, codes, and practices. Review the approvals section of the 3051
reference manual for any restrictions associated with a safe installation.
Before connecting a HART

in the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.
Process leaks may cause harm or result in death.
To avoid process leaks, only use the o-ring designed to seal with the corresponding flange adapter.

Electrical shock can result in death or serious injury.
Avoid contact with the leads and the terminals. High voltage that may be present on leads can cause

electrical shock.
NOTICE
Shipping considerations for wireless products.
The unit was shipped to you without the power module installed. Remove the power module prior to
shipping the unit.
Each power module contains one "D" size primary lithium-thionyl chloride battery. Primary lithium batteries
are regulated in transportation by the U.S. Department of Transportation, and are also covered by IATA
(International Air Transport Association), ICAO (International Civil Aviation Organization), and ARD
(European Ground Transportation of Dangerous Goods). It is the responsibility of the shipper to ensure
compliance with these or any other local requirements. Consult current regulations and requirements before
shipping.
Contents
Wireless considerations
Mount the transmitter
Connect the power module
Trim the transmitter
2
®
-based communicator in an explosive atmosphere, make sure the instruments
. . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
3 Verify transmitter configuration
4 Troubleshooting
8 Product Certifications
8
May 2015
. . . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . .
10
13
14