Basic Setup; Video Setup - AL Tech Mediagate MG-250HD Manual

3. Basic Setup

3.1 Video Setup

This is a guide for setting up the video output of the MG-250HD. You have to setup the MG-250HD's video output mode the same as the
TV set's video input mode.
The MG-250HD has auto-detection of a HDMI connection, so if you connect the MG-250HD to a TV by the HDMI connection, regardless of
the video-output of the MG-250HD, you can still see the screen on a TV or a monitor.
√ When you cannot see video on screen after connecting a video cable, check the following:
1. "TV " – Switch to AV – IN (Video Input) Mode: Turn on TV, and switch to video input mode the same as video connection. See TV user manual.
2. "MG-250HD" – Switch to Video Output Mode: Press [TV OUT] button repeatedly. Whenever you press [TV OUT], video output signal is changed.
3. After you see video on screen, you need to save the video configuration of the MG-250HD by using [SETUP].
TV Video Input Mode
"TV Output" = Composite Mode
Normal Video
"Composite Mode" = C/S-Video
"TV Output" = Composite Mode
Component 480i
"Composite Mode" = C/YPbPr
Component
"TV Output" = Component Mode
480p
"Component Mode" = Select one among 480p, 720p, and 1080i
720p
same as TV input mode
1080i
HDMI
480p
720p
1080i "TV Output" = HDVI Mode
1080p "HDMI Mode" = Select one among 480p, 720p, 1080i, 1080p,
640x480 640x480, 800x600, 1024x768, and 1280x1024, 1600x1200 same
as TV input mode
800x600
1024x768
1280x1024
1600x1200
NTSC, PAL : Select the correct mode for use in your country.
MG-250HD Video Output Mode Connection Jack of TV, MG-250HD
CVBS or Composite Jack
(Generally Yellow Jack)
Component 3 Jack
* Y(Green), Pb(Blue), Pr(Red)
HDMI Jack
26
Video Cable Type
Yellow RCA Cable
(Supplied)
Component Cable
* Y(Green), Pb(Blue), Pr(Red)
HDMI Cable