Windows 2000, Xp - AL Tech Mediagate MG-250HD Manual

1.3.3 Windows 2000, XP

1.3.3 Windows 2000, XP
1) After connecting the MG-250HD, plug in the power cable,
Windows will install the driver automatically. And then,
check the driver installation at Windows [Start > Settings >
Control panel > (switch to classic View on Windows XP) >
system > Hardware > Device manager > Universal Serial
Bus controllers > USB Mass Storage Device ].
2) Check 'My Computer' or 'Explorer', there should be a new
volume. You can now copy data to this volume.
If a new volume does not appear, check if the HDD is
formatted correctly and also check the HDD File system.
Windows 2000, XP detect both FAT32 and NTFS.
.
3) After copying data, always remove the MG-250HD using the
in the Windows right-hand corner. If you
remove icon
don't follow this procedure, data may be lost and the MG-250HD
may be damaged.
When you see a 'Non High-Speed USB Hub Message'
The message will be displayed by Windows XP when you plug
the MG-250HD into a USB 1.1 spec. Host adapter.
20