Table of Contents
Advertisement
3.2 Audio Setup
This is a guide for setting the audio output of the MG-250HD. You can use Stereo or Digital 5.1 ch.
Analogue/DCPM: Select this when you connect the supplied audio cables (Red/White) to a TV or Audio equipment directly.
Encoded Digital: Select this when you want to listen through 5.1Ch/DTS Dolby by connecting receiver (or amplifier) with Optical or Coaxial cable.
① Turn on the MG-250HD and press [SETUP] on the Remote
control.
.
< Setup Procedure >
Move to
[Audio Out] icon and press [OK]. Setup box will be
②
displayed under icon menu.
③ Select [Audio Out] Mode of either Stereo or Encoded Digital.,
and then press [OK].
Finally, press [SETUP] again to save the configuration.
④
28
Advertisement
Table of Contents
