Basic Setup; Video Setup - AL Tech Mediagate MG-45 Manual

3.2 Basic Setup

3.2.1 Video Setup

This is a guide for setting up the video output of MG-45. You have to setup MG-45's video output mode to the same as the TV
set's video input mode.
When you cannot see video on screen after connecting video cable, check following,
1. "TV "– Switch to Video Input Mode: Turn on the TV, and switch it to a video input mode which is the the same as the
MG-45's video connection.See the TV Set's user manual.
2. "MG-45" – Switch to Video Output Mode: Press the [VIDEO] button repeatedly. Each time you press [VIDEO],
the video output signal is changed. When Pressing [VIDEO] leave a 2-3 second pause between each press
. 3. After you see video on screen, you need to save the video configuration of the MG-45 - Go To SETUP>Video Output.
TV Video
Input Mode
Normal Video
S-Video
Component 480i
Component 480p
Component 720p
Component 1080i
NTSC, PAL = The Video output standard. Select the correct one that needs to be used in your Country.
MG-45 Video
Output Mode
TV Out: NTSC C/S-Video
(HD Component OFF)
TV Out: PAL C/S-Video
(HD Component OFF)
TV Out: NTSC C/S-Video
(HD Component OFF)
TV Out: PAL C/S-Video
(HD Component OFF)
TV Out: NTSC C/YPbPr
(HD Component OFF)
TV Out: PAL C/YPbPr
(HD Component OFF)
HD Component Out On 480p
HD Component Out On 720p
HD Component Out On 1080i
Connection Jack
of TV, MG-45
CVBS or Composite Jack
(Usually the Yellow Jack)
S-Video Jack
Component 3 Jack
* Y(Green), Pb(Blue), Pr(Red)
30
Video Cable Type
Yellow RCA Cable
(Supplied)
S-Video Cable
* Black rounded
Component Cable
* Y(Green), Pb(Blue), Pr(Red)