Table of Contents
Advertisement
Chapter 5. Basic Setup of the Mpeg4 Player
1. Video Setup
The default Video Setup is Composite Connection for general TV.
If a general cable (Yellow) is connected, no need to change.
If you want to connect by other cables, select a proper TV system (NTSC / PAL) for a TV to receive
a correct video signal.
For Video Setup, press [SETYP] button on a remote controller.
●●● [Note] : In case, the main page is not appeared ●●●
In case, the main page is not appeared after connecting the proper cables, press [VIDEO] button
until you see the main page (Mpeg4 Player LOGO PAGE) and then press [Setup] button in order to
match [Video] setup with TV and also refer to TV manual.
(1) Setup of TV System (NTSC / PAL)
① Select [Setup] -> [Video Setup] -> Press [Enter] or [▶] button.
② Select [TV Output] by using [▲ or ▼] button.
③ Select a menu by using [▶] and [▲▼] key and press [Enter] for setup.
④ Now, the new configuration is applying. Be sure to press [Enter] button to save the new setup.
⑤ Set other configurations by using arrow buttons or go to other setup pages by pressing [Setup]
button.
(2) Setup of HD Component (Progressive)
In order to use Components connection, the TV MUST support [Progressive].
① Select [Setup] button on a remote controller.
② Select [Video Setup] -> Press [Enter] or [▼] button.
③ Select [HD Component] output by using [▲▼] keys.
④ By using [▶] and [▲ or ▼] button, select a proper one (480p, 720p, 1080i, off) and then press
[Enter] button.
2.5" HDD MULTIMEDIA JUKIBOX
●●● [Note] ●●●
□ NTSC, PAL : Standard of TV Output.
Select a proper one for using in your country.
□ C(Composite) : If a general cable (Yellow)
is connected, no need to change.
□ S-Video : In case, connect by S-Video
cable (Black) and the color is white-black,
need to change the configuration.
□ Y,PB,PR : In case of Component Video
Output
14
Portable MPEG4 Player
Advertisement
Table of Contents
