Connecting To The Power Source; Local Power Option; Figure 4. Connecting To The Local Power Source - ADTRAN IP 712 User Manual

ADTRAN IP 700 Series Phone User Manual
3.

CONNECTING TO THE POWER SOURCE

Once the IP 706 and IP 712 phones have been assembled, it is necessary to connect the phones to a power
source and the phone system. There are two options available to supply power to your IP phone. Use the
Local Power Option if your wall jack is not Power over Ethernet (PoE) enabled. This option requires using
the optional PoE power supply (P/N 1200809E1 or P/N 1200809E#IN). If your wall jack is PoE enabled,
use the Inline Power Option which does not require the optional PoE power supply. Use the following
steps to complete these tasks.

Local Power Option

Use the Local Power Option if your jack is NOT PoE enabled. If your jack is PoE
enabled, a PoE power supply is not necessary.
1. Connect one end of the included Ethernet cable to the Ethernet jack on the back of the phone.
2. Connect the remaining end to the
device.
3. Connect one end of a second Ethernet cable (not included) to the
4. Connect the remaining end of the second Ethernet cable (not included) to the non-PoE wall jack.
5. Connect the PoE power supply to the wall outlet.
Network connectivity is provided through the wall jack, allowing an optional PC
connection through the IP phone. If the IP phone is disconnected from either the network
or power source, network connectivity from the phone to the attached PC will be lost.
6AOSUG0001-1A
J1 DATA AND POWER
5
Optional
PoE Power Supply
3
2
Non-PoE Wall
4
Jack

Figure 4. Connecting to the Local Power Source

Copyright © 2011 ADTRAN, Inc.
Connecting to the Power Source
port on an appropriate PoE-enabled
port on the PoE device.
J2 DATA
1
Optional PC
Connection
17