Enterprise grade sip phone for remarkable value (4 pages)
Summary of Contents for ADTRAN IP700
Page 1
R E L E A S E N O T E S ADTRAN IP 700 Series Phones Firmware version 2.4.1 April 10, 2013...
Page 2
To the Holder of the Manual The contents of this manual are current as of the date of publication. ADTRAN reserves the right to change the contents without prior notice. In no event will ADTRAN be liable for any special, incidental, or consequential damages or for commercial losses even if ADTRAN has been advised thereof as a result of issue of this publication.
• This release is not approved for use with NetVanta ECS in Disaster Recovery Applications. • Phones being upgraded from 1.3.x must first be upgraded to version 1.3.16 (available on ADTRAN’s website at http://www.adtran.com) before proceeding with upgrading to 2.4.1.
INVITE was not sent. • Intermittently, calls received on a SLA/SCA line could not be answered. • In cases where a blind transfer failed or was cancelled, the ADTRAN Phone was not able to transfer the current call. • Intermittently, incoming calls on an idle SLA/SCA line were rejected by the phone.
• When receiving a call, if the phone rings for 60 seconds, it will send a 486 Busy Here message back to the SIP server. Upgrade Instructions Upgrading ADTRAN IP 700 Series phones to the latest version of firmware is explained in detail in the configuration guide Upgrading IP 700 Series Phones Firmware, available at https://supportforums.adtran.com.