Assembling The Phone; Attaching The Desk Stand; Figure 2. Assembling The Desk Stand - ADTRAN IP 712 User Manual

ADTRAN IP 700 Series Phone User Manual

Assembling the Phone

The IP 706 and IP 712 phones require minimal assembly. The parts that must be assembled include the
desk stand and handset.

Attaching the Desk Stand

1. Insert the stand through the bracket (rotating it so it fits through the opening).
2. Once through the bracket opening, rotate the stand back and pull it toward the bracket until seated.
3. Make sure the stand is properly oriented within the bracket as shown in
4. With the desk stand assembled, insert the top two tabs into the corresponding slots on the phone
back.
5. Insert the remaining tabs in the order shown in
pressed inward at the same time to snap into the slots.
6. Once the desk stand is installed, use the sliding latch on the back to adjust the phone to the
preferred tilt. To remove the desk stand for wall mounting purposes, simply push in the tabs along
the side and lift the desk stand from the back of the phone.
The IP 706 and IP 712 phones may be wall mounted using the optional wallmount kit
(P/N 1200808E1). For wall mounting instructions, refer to the IP 700 Series Wallmount
Kit Quick Start Guide shipped with the kit.
6AOSUG0001-1A
Figure 2
Bracket
Top
Stand
Phone Back
1
2
4
3
5

Figure 2. Assembling the Desk Stand

Copyright © 2011 ADTRAN, Inc.
Assembly and Installation
Figure 2
below. The two Tabs 4 and 5 must be
Desk Stand
Unit
below.
15