ADTRAN IP 700 Release Notes
Ip 700 series phones firmware version 2.3.0
Hide thumbs
Also See for IP 700:
- Administrator's manual (87 pages) ,
- Release notes (6 pages) ,
- Quick reference manual (2 pages)
Related Manuals for ADTRAN IP 700
Summary of Contents for ADTRAN IP 700
- Page 1 R E L E A S E N O T E S ADTRAN IP 700 Series Phones Firmware version 2.3.0 October 5, 2012...
- Page 2 To the Holder of the Manual The contents of this manual are current as of the date of publication. ADTRAN reserves the right to change the contents without prior notice. In no event will ADTRAN be liable for any special, incidental, or consequential damages or for commercial losses even if ADTRAN has been advised thereof as a result of issue of this publication.
-
Page 3: Table Of Contents
..........This section explains notes regarding the IP 700 Series phones.. -
Page 4: Introduction
• This release is not approved for use with NetVanta ECS in Disaster Recovery Applications. • Phones being upgraded from 1.3.x must first be upgraded to version 1.3.16 (available on ADTRAN’s website at http://www.adtran.com) before proceeding with upgrading to 2.3.0. -
Page 5: Fixes
• Ringback tone was not heard when placing a call from the NetVanta BCS ucCompanion or the NetVanta 7000 Personal Phone Manager using the click-to-dial capability. • IP 700 Series phones would not play ringback tone when it received a 180 Ringing response after a 183 Session Progress response. -
Page 6: Upgrade Instructions
• When receiving a call, if the phone rings for 60 seconds, it will send a 486 Busy Here message back to the SIP server. Upgrade Instructions Upgrading ADTRAN IP 700 Series phones to the latest version of firmware is explained in detail in the configuration guide Upgrading IP 700 Series Phones Firmware (ADTRAN’s Knowledge Base article...