Table of Contents
Advertisement
VII. EXERCISE COMPUTER
INSTRUCTION MANUAL
OVERVIEW:
The unit is an electronic that display all workout parameters on LCD display. The workout parameters
include: Odometer (If have), Time, Speed, Distance, Calories and Pulse (If have). All workout parameters
may be selected by the select key.
MODE OR FUNCTION
Power on
Select function Scan
Odometer(If have)
Time
Speed
Distance
Calories
Pulse(If have)
Reset
Auto off
ACTION
If push the button, the unit will be on and display the parameters of the last
exercise.
Push the button, the unit will display 5 parameters one by one. Push the
mode key until the "SCAN" signal shows on right down side. The unit will
scan by through Time, Speed, Distance, Calories and Pulse each for 4 sec-
onds.
Push the mode key again, the scan will stop and the "SCAN" signal will dis-
appear. If push the button until the "ODO" points to "ODO", the display shows
the Odometer on the meter. The reading of the odometer will be reset to zero
after replacing the batteries.
Push the mode key until the "TMR" points to "Time" to display the exercises
time. If the bike stop moving, the unit will stop count time also.
When the "SPD" points to "SPD" to display the speed value. Unit: km/h.
When the "DIST" points to "Dist" to display the distance value. Unit: km
When the "CAL" points to "CAL" to display the calories value. Unit: K Cal.
When the "PULSE" points to "pulse" to display the heart rate of biker in per
minute. If the sensor is contact with ear, clip the sensor to earlobe before
measuring your pulse rate. If the pulse sensor is contact with hand, place
the palms of your hands on the both of the contact pads before measuring
your pulse rate. If the pulse signal is not in put over 30 second, the unit will
return the "Time" function.
Push the mode key over 3 seconds the showing will become to zero.
The unit will be off if the speed signal stops over 4 minutes.
EXERCISE COMPUTER INSTRUCTION MANUAL |
17
Advertisement
Table of Contents
