Table of Contents
Advertisement
ATTENTION:
Connected with the computer line,
to Gap (A1) corresponding to the
convex point (A2) to insert link.
STEP 3
1. Slide the Handlebar Post (pt.17) into the handlebar post housing on the main frame. You will have
to slacken the knurled section of the Knob (pt.7) and pull the knob back and then select the desired
height. Release the knob and retighten the knurled portion.
2. Then the Handlebar (pt.18) and the supporting plate (pt.64) fixed on the Handlebar Post (pt.17),
use four Bolts (pt.20) and four Spring Washers (pt.19) to tighten. Finally, the Computer (pt.65)
inserted on the supporting plate.
ATTENTION: YOU SHOULD FIX THE HANDLEBAR TIGHTLY.
A1
Gap
Convex Point
A2
65
64
A2
ASSEMBLY INSTRUCTIONS |
A1
20
19
18
17
7
11
Advertisement
Table of Contents
