Table of Contents
Advertisement
A-18
A
A: CLI C
PPENDIX
OMMAND
show ethernet settings
show ip settings
show memory
show port <port
number> settings
show security_option
settings
show snmp counters
D
ESCRIPTION
OUTPUT COUNTERS
Octets - bytes transmitted
Ucast - unicast packets transmitted
MultiCast - multicast packets transmitted
Discards - Number of outbound packets which were chosen to be discarded
even though no errors had been detected to prevent their being transmitted.
One possible reason for discarding such a packet could be to free up buffer
space.
Errors - For packet-oriented interfaces, the number of outbound packets that
could not be transmitted because of errors. For character-oriented or
fixed-length interfaces, the number of outbound transmission units that could
not be transmitted because of errors.
Out QLen - length of the output packet queue (in packets)
Displays settings for the ethernet interface.
Displays system wide IP information.
IP System Host Address - IP address of the system
IP Forwarding – always DISABLED
WAN to WAN Forwarding – indicates if forwarding between WAN Bridge
ports is allowed.
Displays System RAM Memory usage.
Total System Memory Resources - total amount of memory in system
Free Memory - amount of memory not in use
Code Size - amount of memory used by code
Initialized Data Size, Uninitialized Data Size, Stack Size - static data areas
Displays the parameters defined for the specified VC. You can use list vc to see
which virtual channels are defined.
Displays status for SNMP User Access and Administration by Remote Users. You
can modify the SNMP User Access using the enable or disable security_option
snmp commands. You can modify Administration by Remote User using the
enable or disable security_option remote_user commands.
SNMP User Access - ENABLED (default) or DISABLED
Administration by Remote User - ON or OFF
Displays many SNMP statistics.
INPUT COUNTERS
Packets - number of SNMP packets received
Advertisement
Table of Contents
