List Ip Networks; List Ip Routes; List Ports; List Snmp Communities Or List Snmp Trap_Communities - 3Com HomeConnect 3CP3647 Cli User's Manual

list ip arp

list ip networks

list ip routes

list ports

list snmp communities
or list snmp
trap_communities
Interface - interface this IP address uses to connect to the system
Displays the contents of the ARP cache. It lists:
IP Address - IP address for this entry
Phys Address - MAC address that the IP address maps to
Type - interface type: Ethernet or Token Ring
If Name - eth:1, DA:1 or loopback
Displays all the IP networks you previously defined using the add ip network
command. It also lists:
Name - network designation
Prot - always the IP protocol
Int - name of the interface this network runs on
State - state of the network; ENABLED or DISABLED
Type - STATIC or DYNAMIC network
Network Address - address of the IP network
Displays all the statically defined IP routes that you previously defined using the
add ip route command. It lists:
Destination - IP address that the route resolves to
Prot - LOCAL
NextHop - address of the gateway used to reach this route
Metric - number of router hops away this route is from the system
If - interface that the route uses
Lists all bridge ports, showing:
Name - user designation you specified using add vc
Network Service - type of network service: e.g., RFC1483
VPI - Virtual Path Identifier
VCI - Virtual Channel Identifier
Status - link status: ACTIVE, INACTIVE or DISABLED
These commands display the defined SNMP communities, which you previously
defined using the add snmp community command. SNMP trap_communities does
not list access.
Community Name - community designation for the IP address
IP address - IP address of a member of the community
Access (Read/Write) - type of access a member has to MIBs
CLI Commands A-9