Table of Contents
Advertisement
update software tftp
<filename>
VERIFY
verify filter
<filter_name>
TELNET
Commands
close
help
send <string>
set_escape <string>
status
CLI Exit
Commands
Bye, Exit, Leave, Quit
server <ip_addr>
path <path>
Verifies the syntax of a filter file, which has been previously added to the table. If
you update a filter file and TFTP it to the FLASH file system, and the file already
exists in the filter table, then you use this command to verify the files syntax. You
can use list filters to see which files are currently in the filter file table, and what
the status of each is.
The following commands are available to TELNET users. They are accessed by
pressing control - ].
Closes the active TELNET connection.
Lists the available commands
Transmits a TELNET control character. Be sure the parameters are uppercase. The
choices are:
Parameters
Description
AYT
Are you there
IP
Interrupt process
BRK
Break
AO
abort output
EC
erase character
EL
erase line
GA
go ahead
NOP
no - operation
EOR
end of record
SYNC
synch
Allows changing the TELNET escape character from ^] to something else. Control
characters are specified using the carat character followed by another character.
For example, to set the TELNET escape character to control - X, type set_escape
^X.
Displays the IP address of the remote host and the value of the TELNET escape
character.
These commands are available to TELNET users so they can disconnect from the
CLI.
Leave the CLI, but keep this connection open. This command returns you to the
TELNET commands.
TELNET Commands
A-21
Advertisement
Table of Contents
