Chapter 6 Troubleshooting; Running The Diagnostic Program - 3Com EtherLink 3C529 User Manual

Chapter 6
Troubleshooting
This chapter describes information for isolating and
solving problems.

Running the Diagnostic Program

Run the diagnostic program on your installed 3C529
adapter to test for setup/configuration or physical board
problems. The program is located on the EtherDisk
diskette.
The diagnostic program contains three groups of tests.
Group 1 tests the physical components, connectors,
and circuitry on the adapter.
Group 2 verifies the adapter's ability to transmit data
over the network.
Group 3 verifies the adapter's ability to transmit and
receive data while on the network.
The diagnostic program tests the adapter, not the
network.
NOTE: Make sure that no network drivers or memory
managers are installed before you run the Configuration
and Diagnostic Program.
Troubleshooting 6-1