Jack Up Procedure; Figure 6 - Moving The Machine On Tir Rollers; Figure 7 - Jack-Up Procedure - York YHAU-CW Manual

FORM 155.31-ICOM2.EN.UL
ISSUE DATE: 12/21/2018
If using a tir roller to move the machine, fit the tir roller
set to each of the four holes shown in the figure below.

FIGURE 6 - MOVING THE MACHINE ON TIR ROLLERS

JACK UP PROCEDURE

When jacking the machine, be sure to fit the jack in
each of the jack-up supports as shown below.
Jack-up
Support

FIGURE 7 - JACK-UP PROCEDURE

JOHNSON CONTROLS
SECTION 3 – HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
Hole (Ø22) for Fitting Tir Roller Set
Anchor Bolt Hole
Tir Roller Set
Machine Base
Jack-up
Support
Jack
Jack-up
Support
Tir Roller Set
Jack-up Jack-up
Support Support
LD22948
3
LD22947
25