Selecting Co2 Unit Of Measurement/Co2 Scale - Dräger Vamos Operating Instructions Manual

Operation in Measurement Mode

Selecting CO2 Unit of Measurement/CO2 Scale

To set alarm limits :
Turn or press dial knob to select main menu.
Turn dial knob to select the »Alarm« parameter.
Press dial knob to open the parameter menu.
Turn dial knob to select the alarm limit to be edited.
Press dial knob to confirm selection.
The selected alarm limit will be marked with an arrow.
Turn dial knob to set the alarm limits.
Press dial knob to confirm settings.
Press dial knob to return to the main menu.
Press dial knob again to return to the measurement display.
Selecting CO Unit of Measurement/CO
2
On power-up, the monitor uses the following default values:
— CO unit: as set during last power-on.
2
— 0 to 50 mmHg (0 to 6 Vol.%, kPa) for the CO
The following units can be selected as units of measurement
for CO :
2
— mmHg
— Vol%
— kPa
The following ranges can be selected for the CO
measurement scale:
— 0 to 50 mmHg (0 to 6 Vol.%, kPa)
— 0 to 75 mmHg (0 to 10 Vol.%, kPa)
Turn or press dial knob to select main menu.
Turn dial knob to select »CO
Press dial knob to open the parameter menu.
Turn dial knob to set units for CO
set the scale of the CO
2
Press dial knob to confirm the settings.
The selected unit of measurement and the selected scale
are marked with an arrow.
Press dial knob to return to the main menu.
Press dial knob again to return to the measurement display.
The set unit will be used until it is changed by the user again.
26
Scale
2
scale.
2
2
« parameter.
2
, and, if necessary, also
2
waveform.
RETURN TO THIS MANUAL'S TABLE OF CONTENTS
RETURN TO CD-ROM TABLE OF CONTENTS
Alarm lo
FiCO2
EtCO2
FiHal
SpO2 92
HR 80
F 0.6
i Hal N2O
[%] [%]
F 0.1
et
CO2
Unit mmHg
Vol%
kPa
Range 0-6
0-10
F 0.6
i
Hal N2O
[%] [%]
0.1
F
et
hi exit
SpO2 98
0.7
[%]
7.0
1.5 Pulse 110
[1/min]
150
0.0
30
CO2
[%]
25 4.5
exit SpO2 98
[%]
Pulse 110
[1/min]
30 0.0
CO2
[%]
4.5
25